HEISENBERG POLLENMASCHINE Benutzerhandbuch Seite 5

1. Open cover and remove sieve
Carefully lift the sieve out of the white plastic
suspension on one side. Then you can pull
it out of the brass mounting and remove it
from the machine.
3. Set speed and switch on
The rotation speed is adjusted on the power
supply unit by increasing or decreasing the
voltage. On the side of the pollen machine is
the on switch. While the machine is in ope-
ration, make sure that the cover remains
closed.
Let the pollen machine run at the highest level for 2-3 minutes in the first pass to obtain the
highest quality pollen. After that you can start the machine again and let it run for 15-30
minutes at an average of 8 volts. Note: The longer the pollen machine runs, the lower the
2. Open sieve and fill with dry plants
You open the sieve by removing the magne-
tic lid. Add the dried plants. The best results
are achieved if you do not overfill the sieve.
It is sufficient to fill the sieve halfway. Then
hang the sieve back in the machine.
4. Lift out sieve and remove pollen
Remove the sieve from the machine as de-
scribed in the first step. Now you can collect
the extracted pollen from the floor and walls
with a brush and remove it for further pro-
cessing.
Expert Advice:
quality of the pollen.