Gardol Pure Line Bedienungsanleitung Seite 8

• Observe and follow all the local building ordinances. Apply for permission from local authorities if
necessary. Always check with local authorities to ensure your shed is up to code.
• Do not let children climb on or play around the product.
• Always assemble the pr
• Do not use this product if any parts are missing, damaged, or worn.
• Do not over-tighten the fasteners.
• The roof covering may only be installed using a stable ladder. The roof may not be entered
during assembly and for snow removal.
Before assembly
DANGER - Risk of Suffocation!
Keep any packaging materials away from children and pets – these materials are a potential
source of danger, e.g. suffocation.
• The product is delivered in two separate boxes. For detailed information, please refer to chapter
"Part List" and tables 1 (box 1) and 2 (box 2). The three columns of each table specify part no.,
drawing and quantity.
• Remove all the packing materials.
• Remove and review all components before starting assembly.
• Place all the components on a cloth or plastic sheet to avoid damage.
• Organize all the components according to the part numbers indicated on each component.
• Check all the components for transport damages.
• Prepare all the personal protective equipment (PPE) and all the tools required for assembly.
CAUTION
• The product must be anchored to a solid base foundation, such as concrete slab or treated
timber.
• Do not assemble the products on soft ground directly, such as lawn, soil or gravel. For a
suitable concrete or wooden base foundation, contact an authorized local building dealer.
Notice
•
• Make sur
•
• Avoid locations with low hanging branches, as heavy branches could fall and damage the
product.
• Avoid assembling the product in a low-lying area that collects water or that lies at the bottom
of a hill.
• Small trees, bushes or fences around the product can be helpful to act as a windbreak.
• If concrete slab is used, it is important that it slopes towards the edges to prevent water
collection.
• Plan in advance. If concr
assembly.
• Be careful not to dig into the ground where water pipes, gas lines, or electrical cables are
lying.
• Avoid placing the product anywhere near a septic tank, if present in the vicinity.
• If using a drill driver, set the torque to #4 to ensure the screws do not strip the metal
reinforcements.
round.
round the product.
roots or clumps of rocks.
round. Level the base frame using a spirit level.
8
rete to dry before