Introduction; Information On This Manual; Safety; General Safety Instructions - Rational HGW Extension 20-2/1 Original Installationsanleitung

en
1

Introduction

1.1 Information on this manual

This document is a preliminary version of
the installation manual. Please note the rel-
evant version and date.
These instructions describe the installation
of the raiser for mobile oven rack for floor
units:
LM1: iCombi Pro (iCP) 20-2/1
n
LM2: iCombi Classic (iCC) 20-2/1
n
This manual is to be used in addition to the
installation manual for iCombi Pro /
iCombi Classic. Read the manual before
assembly. The manual is there to ensure
that you use the units safely and install
them properly.
The illustrations in this manual are ex-
amples only and may differ from the as-
sembly kit.
All information from the installation
manual for iCombi Pro / iCombi Classic
apply accordingly.
2

Safety

2.1 General safety instructions

This unit is designed in such
a way that it presents no
danger if installed according
to instructions. This manual
describes how to install the
unit correctly.
Adhere to the relevant local
n
regulations and standards in
your country.
8 / 60
Use carrying aids such as
n
carrying straps during trans-
portation.
Secure the unit against tip-
n
ping during transport, after
setting up at the installation
location.
Wear appropriate protective
n
clothing, such as protective
gloves and safety shoes,
when transporting and in-
stalling the unit.
The appliance must be in-
n
stalled in a frost-resistant,
non-windy and protected
environment.
Do not expose the unit to
n
weather conditions such as
rain.
Only connect the unit in ac-
n
cordance with the installa-
tion manual and the informa-
tion on the nameplate.
Switch the unit off before
n
disconnecting the mains
power or connecting to the
mains.
After use, only transport the
n
unit at ambient temperatures
above 0°C [32°F].
80.51.917_iCombi Pro-iCombi Classic_HGW-Extension
1 | Introduction
202_IM_V01_EU-west