HYTE Revolt 3 Handbuch Seite 3

Assembly Instructions
Revolt 3 is designed to be easy to build, but it is still a small form factor case which means not every
step is obvious. We've included the most important steps in this manual as a quick start guide, but for
more detailed instructions, scan the QR code or check out Revolt 3's page on HYTE.com.
For more detailed instructions, scan the QR code
1
Remove Side Panels -
removed easily by hand, the top panel is secured by 4 screws.
2
Install Power Supply -
Start by removing the rear panel by pulling from the bottom. The 4 side panels can be
Skip these steps if your Revolt 3 comes with its power supply pre-installed.