Wiesel V3 Bedienungsanleitung Seite 16

Set Support Speed
You can set the speed up to which the motor should support. The standard setting for a new
Wiesel tuning module V3 is 35 km/h.
First carry out the calibration from the previous chapter.
To enter the mode to set the cut-off speed:
1) Switch on your eBike
2) Move the magnet exactly 4 times in front of the speed sensor
3) Switch off the e bike for about five seconds and then switch it on again
Switch ON
The mode for setting the maximum support speed is now active and the speedometer shows
the current setting (e.g. 35 km/h). By moving the magnet past the sensor, you can now go
through all the setting options:
Possible switch-off speeds: 31 to 50 km/h in 1 km/h increments
To apply the setting you have made, simply switch off the eBike. The setting is saved
permanently.
At a driving speed of 35 km/h, 25 km/h are displayed on the speedometer. At a speed of e.g.
40 km/h, 30 km/h are displayed (i.e. 10 km/h less than real).
16 Operating Manual
4 Pulses Switch OFF
Switch ON
Set Cut-Off Speed