Blowing Function; Technical Characteristics; Filter Cleaning - STENDA Limpar Basic 800 Watt Bedienungsanleitung

- Never empty the container into highly flammable objects, and make sure that the ashes are
completely cold.
- Insert the plug into the power outlet.
- Turning on: Put the ON/OFF switch in the I position.
- Switching off: Put the ON/OFF switch in the O position.
- Vacuum the ashes by means of the aluminum pipe directly out of the fireplace or stove. Keep
the opening of the vacuum at about 1 cm away from the ashes.
- Move the vacuum aluminum pipe slowly and evenly by pressing it gently.
- After use, turn off the device by setting the ON/OFF switch to O, and then take the plug out
of the power outlet.
- After you finish with cleaning operations, clean the device and vacuum filter.

Blowing function

Insert the appropriate metal hose (24) connector (23) into the blowing opening, located on the
motor cap (5), as deeply as possible. Once the vacuum cleaner is on, you may use the vacuum hose
to blow dust, leaves, etc.

Technical characteristics

Mains Voltage
Rated power input
Vaccum
Container capacity
Metal hose length
Aluminium pipe length
Power cable length

Filter cleaning

Before you start any form of cleaning or maintenance, always take the plug out of the power
outlet.
1. Dismantle the filter
2. Shake off the filter
3. Wash the filter
4. Leave the filter to dry thoroughly, before you reinstall it.
230V/50Hz
800 W
16 kPa (160 mbar)
15 L
800mm
230mm
3.5m
15