Repairs; Operating Instructions - STENDA Limpar Basic 800 Watt Bedienungsanleitung

- Check carefully if the cable, plug or parts of the device are damaged. If so, do not use the
device, but contact the repair service for repair.

Repairs

Use only the equipment, accessories, and spare parts recommended by the manufacturer. In case of
any damage to the equipment, despite our quality controls and your maintenance, the repairs may
be made by the qualified electrician only in an authorized service center.

Operating instructions

No. Name
1 Handle
2 Switch
3 Clasp
4 Insulation sleeve
5 Motor cover
6 Sponge
7 Power cable
8 „O" seal loop - „O" ring
9 Capacitor
10 Wire connector
11 Motor
12 Circularity seal
13 Cover
- Insert the washable filter (17) at the bottom of the motor base.
- Make sure that the metal hose connectors (23) and (25) are installed in the right place. Fix
the metal hose connector (23) tightly in the input connector (22) on the container and lock it
by turning it clockwise. (To remove, turn it counterclockwise). Then, connect the aluminum
pipe (26) to the other end of the metal hose (24) - into the metal hose connector (25).
WARNING!
- Before your start vacuuming ashes, make sure they are cold and not burning. Do not vacuum
glowing ashes.
No. Name
14 Label
15 Container cover
16 Screw
17 Filter
18 Filter cloth
19 Container
20 Container lock
21 Rivet
22 Outer connector
23 Metal hose connector
24 Metal hose
25 Metal hose connector
26 Aluminum pipe
14