Adjust Power Limiting As Required - Superrollo TA50 Einbau- Und Bedienungsanleitung

Adjust power limiting as required
NOTE
The door operator is preset to stage 3 by the supplier.
If required (e.g. if the power level is too low) you can
subsequently adjust the power limiting setting.
1. Press „+" (if necessary
press several times) until
„4" is displayed.
Low
4. Press „P", in order
to store the setting.
After a resetting of the power level, it is absolutely necessary to repeat the reference run for power
limiting and to conclude the programming again.
During the reference run there is a risk of injury as the door operator develops extremely strong forces.
2. Press „P", the display
shows „7" (stage 3).
Power level
Factory setting
5. IMPORTANT
Repeat reference run
for power limiting
(refer to page 54).
If the power level is too low, the door
movement will be impaired, particularly if
the mechanical structure of the door is not
well balanced.
3. Press „+" or press „-"
to select the stage.
6. Conclude programming
(refer to page 59,
method 1).
EN
High
55