Setting The Timer - KLAMER Black 72193 Serie Bedienungsanleitung

Using the Ice Cube Maker
1. After inserting the plug into the socket, the device will turn on by
itself and the display will light up.
2. Fill the ice cube maker with drinking water (max. 2.2 L) and select
the size of the ice cubes via the SELECT button:
S = Small (approx. 7 minutes freezing time).
M = Medium (approx. 9 minutes freezing time)
L = Large (approx. 11 minutes freezing time)
3. Press the ON / OFF button (it has the snowflake symbol). Ice cube
making will begin and the snowflake icon will flash until ice cube
making is complete.
4. After the ice cube making is finished, the ice cubes can be taken
out with the scoop.
Filling the unit with water
1. When you fill water into the ice cube maker, a good orientation for
the water level is the bottom of the ice cube tray. If this water level is
not high enough and the machine doesn't start producing ice
cubes, slowly add more water until it starts.
2. You can refill water at any time - but only use drinking water at
room temperature.
Tip
You can easily check the recommended filling level with water:
As soon as the water rises through the round holes in the bottom of the ice
cube tray, there should be enough water.
17

Setting the Timer

1. Timer mode has four different setting modes:
- Timer not active: TIMING is visible on the display.
- Start timer only: TIMING and ON are visible on the display
- End timer only: TIMING and OFF are visible
- Start and end timer: TIMING, ON and OFF are visible
2. By pressing the SET key several times, set the timer start time
(when the device will start producing) and timer end time (when the
device will end producing).
3. Now press the triangle button to select the appropriate timer mode
(see above).
ON OFF
TIMING
M
TIMING
1
When Ice Cubes are done
1. When the ice cube tray is full, this is indicated on the display via the
icon. Remove the ice cubes from the unit to continue ice cube
preparation.
2. If the water level is too low to produce more ice cubes, this is
indicated by the corresponding icon on the display. Refill with water
to continue ice cube production.
L M
ON OFF
TIMING
ON OFF
TIMING
1
Ice cube tray full
SET SELECT
M S
S
ON OFF
TIMING
SELECT
1 1
L
SET SELECT
1
Water level low
18
M S