Wheel Zone 57085 Anleitung Seite 2

en
BICYCLE LOCK
with fingerprint sensor
Things to do before first use:
Fully charge the padlock battery via the built-in microUSB
connector.
Charging is indicated by continuously lighting red LED next to the
fingerprint sensor. A fully charged battery is indicated by the red
LED turning off. Then unplug the cable and the device is ready for
use. The battery lasts for approx. 800-1000 opening and closing
with one charge. It is recommended to recharge the battery
every 1-2 months. When the battery level is low, the red LED on
the device flashes 5 times and the green LED flashes 1 time when
the padlock is opened.
ADMIN fingerprint registration:
In the factory state, the padlock opens for any fingerprint, to
register the first fingerprint, hold your finger on the sensor until
the blue LED lights up continuously. Then tap your finger 5x
on the sensor, each time you touch, the successful fingerprint
reading is confirmed by a green LED. After that, the padlock only
opens by using this fingerprint.
Second ADMIN fingerprint registration:
Only by confirming with the first ADMIN fingerprint can be added
a second ADMIN fingerprint. Hold your finger for approx. For 5
seconds on the sensor until the blue LED is lit continuously.
Then tap 5 times the finger you want to register as the second
ADMIN. Each time you touch, the successful fingerprint reading is
indicated by a green LED.
The first two registered fingerprints will have ADMIN authority.
These fingerprints allow you to add additional fingerprints or
delete all fingerprints from the system.
New fingerprint registration:
As with the previous fingerprint registration, place one of the
ADMIN fingers on the sensor and hold it for approx. 5 seconds
until the blue LED is lit continuously. Then place the finger 5
times on the sensor you want to register. Each time a fingerprint
is scanned, a green LED indicates successful reading and saving.
You can then use this fingerprint to open the padlock, but this
fingerprint can no longer record additional fingerprints because
you do not have sufficient privileges. (total 2+18 fingerprint use)
Factory reset - delete fingerprints:
It is possible to restore the factory condition, ie the padlock will
open with every fingerprint, as it was new. This will require one
of the fingerprints with ADMIN authority. Place your finger on
the sensor and hold it for approx. For 8 seconds until the red LED
1
2
3
4
57085
lights up. Lift your finger up and touch the sensor once again. This
confirms your intention to delete the stored fingerprints, which is
indicated by the flashing of the green LED.
Installation, use:
Store the bicycle padlock when not in use on the included bicycle
bracket, which you can attach to the bicycle with two screws.
Use the red button to remove the padlock from the bracket. The
bracket should be positioned so that the padlock is less exposed
to possible environmental influences, for example by placing
the bracket on the seatpost. Always close the padlock cover to
protect the sensor and microUSB connector from the weather.
Technical details:
Battery type:
Battery capacity:
Battery life:
Connector:
Sensor size:
Number of stored fingerprint:
Splashproof:
Protection:
Operating temperature:
Wire length:
Wire thickness (without coating): 4 mm
Material:
Color:
5
1. lid
2. USB charging port
3. LED indicator
4. fingerprint sensor
5. lock shackle
3V Polymer Li-Ion
150 mAh
aprox. 800 - 1000 opening/
closing (max 3 month)
MicroUSB 3V, 200 mA
12 x 12 mm
20 pcs
Yes
IP65
-10 °C – +45 °C
150 cm
Steel
Black