Parts List; Technical Specifications - JBM 52542 Bedienungsanleitung

REF. 52542
9. Install the safety lever on the second hole on the left
hand-side of bottom rack (#14). Put the safety spring
(#12) between the bottom rack (#14) and safety lever
(#11).
10. Press the safety lever and match the holes on the
lever (#11) with the holes on the bottom rack (#14).
Then use the long bolt (#6) to connect them.
11. Use the nut (#2) to tighten the long bolt (#6).
OPERATION
1. Lay the head cushion (#15) flat using the safety lever
(#11).
a) To adjust the head cushion, disengage the lever
from the teeth of the stop plate in head rack (#13).
b) Simultaneously use one hand to pull up on the
head cushion, while using a second hand to push
the safety lever down and back
2. Keep your head flat on the head cushion while sliding
under the vehicle. Then, pull the head cushion into a
comfortable angle.
3. Lay the head cushion flat to slide the creeper out from
under the vehicle
MAINTENANCE
• Wipe down cushions with a damp cloth.
• Clean off any grease or debris accumulated on the
casters.
• Check the creeper and tighten the bolts and nuts if
necessary.

PARTS LIST

Description
Number
1 Screw
2 Nut
Washer
3
4 Short bolt
5 Internal hex bolt
6 Long bolt
7 Hex key
8 Double open end wrench
9 Caster
10 Support rack
11 Safety lever
12 Safety spring
13 Head rack
14 Bottom rack
15 Head Cushion
16 Middle Seat Cushion
17 Bottom Seat Cushion

TECHNICAL SPECIFICATIONS

Maximum weight capacity
(unfolded)
Maximum weight capacity
(folded)
Caster dimensions
Caster material
Seat cushions
Head cushion
Unfolded dimensions
Folded dimensions
Weight
· 5 ·
Quantity
11
10
10
2
17
1
1
1
7
4
1
1
1
1
1
1
1
135kg
115kg
63mm (diameter) x 19mm
(thickness)
PP plastic
35mm high density foam
66mm high density foam
1180x420x105mm
650x420x475mm
12,7kg