Product Presentation; Safety Instructions - JBM 52542 Bedienungsanleitung

EN EN EN EN EN EN
MANUAL OF INSTRUCTIONS MANUAL OF INSTRUCTIONS MANUAL OF INSTRUCTIONS MANUAL OF INSTRUCTIONS MANUAL OF INSTRUCTIONS MANUAL OF INSTRUCTIONS

PRODUCT PRESENTATION

This product is designed to carry out any mechanical tasks
and can be used both as a flat creeper to work underneath
the car or as a normal seat.
It is equipped with a safety pin while being used as a seat
and the upper part is slightly inclined, which together with
the high-density foam cushion, provides an exceptional
comfortability.

SAFETY INSTRUCTIONS

• Wear safety googles and heavy-duty work gloves
during assembly.
• Keep assembly area clean and well lit.
• Do not expose to heat.
• Once assembled, do not attempt to take this product
apart.
• Inspect before every use. Do not use if parts are loo-
se or damaged.
• Do not exceed listed weight capacity.
• Do not work under a vehicle raised on a jack. Su-
pport vehicle on jack stands.
• If the vehicle is on the ground, block the tires and set
the parking brake.
ASSEMBLY
1. Caster installation: Use the internal hex (#5) and the
hex key (#7) to install the casters (#9) as below:
2. Support rack installation: Use 2 pieces of internal hex
bolt (#5), 2 pieces of nut (#2), 2 pieces of washers
(#3), and 2 pieces of short bolts (#4) to install the
support rack (#10).
3. First put the washer (#3) on the standard bolt:
4. Put the nuts (#2) into the hole of the support rack
(#10):
5. Install the first rack externally and use internal hex
bolts (#5) to fix the rack at A and C holes:
6. Install the second rack internally and fix at B and E
points:
7. Repeat the steps 2-6 on the other side.
8. Cushion installation: Use the screws (#1) to install
the head cushion (#15) and middle seat cushion
(#16) onto the head rack (#13), and the bottom seat
cushion (#17) onto the bottom rack (#14).
· 4 ·
REF. 52542