Partyspace LIGHTHOUSE 2100 Bedienungsanleitung Seite 6

GROUND FIXING (IF WANTED)
1. Place the product in the desired location
(concrete surface recommended) in accordance
with the safety regulations and user guidelines.
Mark three points on the ground around the
heater as shown in diagram A. Remove the
product to proceed to the next step.
2. Drill a hole on each point as marked f rom step
one with an appropriate (concrete) drill. The
expansion bolt is 6 mm in diameter.
3. Place the product back in the desired location
and put the f ixing clips (6) on the previously
drilled holes as shown in diagram B.
4. Tap the expansion bolts (B) into the pre-drilled
holes and tighten each bolt with a spanner.
LIGHTHOUSE 2100 | MANUAL