Abnormity And Solution - ATLAN 3388A 60CM Bedienungs- Und Montageanleitungen

8 Abnormity and Solution

Fault
Light on, but motor
does not work
Light does not
work, motor does
not work
Oil leakage
Shake of the body
Insufficient suction
The machine
inclines
Cause
The leaf blocked
The capacitor damaged
The motor jammed bearing
damaged
The internal with of motor off or
a bad smell from the motor
Beside the above mentioned, check the following:
Light damaged
Power cord looses
One way valve and the air
ventilation entrance are not
tightly sealed
Leakage from the connection of
U-shaped section and cover
The leaf damaged and causes
shaking
The motor is not tightly hanged
The body is not tightly hanged
The distance between the body
and the gas top too long
Too much ventilation from open
doors or windows
The fixing screw not tight
enough
The hanging screw not tight
enough
Solution
Get rid of the blocking
Replace capacitor
Replace motor
Replace motor
Replace lights
Connect the wires as per
the electric diagram
Take down the one way
valve and seal with glue
Take U-shaped section
down and seal with soap
or paint
Replace the leaf
Lock the motor tightly
Fixed the body tightly
Readjust the distance
Choose a new place and
resemble the machine
Tighten the fixing screw
and make it horizontal
Tighten the hanging
screw and make it
horizontal
Seite 28 von 48