Hamilton Beach Commercial HMI Serie Bedienungsanleitung Seite 3

SWITCH OFF ( ) before withdrawal from the
25.
mixture.
DO NOT allow water/mixture to enter the
26.
motor housing slots when using or cleaning.
Do not hold blender by the blender
27.
attachment shaft or whisk gear box. Only
position hands on attachment grips and base
handle.
To comply with EN 61000-3-11, the product
28.
must only be connected to a power supply
with system impedence (Zsys) of 0.311
Ohms or less. Before connecting to a
public power network, please contact the
local power supply authority to ensure this
requirement is met.
The EC declaration of conformity for this appliance is available in the Technical Support section
of our website www.hamiltonbeachcommercial.com.
Recycling the Product at the End of Its Service Life
The wheeled bin symbol marked on this appliance signifies that this equipment should be taken over
by a selective collection system conforming to the WEEE Directive so that it can be either recycled or
dismantled in order to reduce any impact to the environment. The user is responsible for returning the
product to the appropriate collection facility, as specified by your local code. For additional information
regarding applicable local laws, please contact the municipal facility and/or local distributor.
w WARNING
Pinch, Cut, and Crush Hazard
Make sure that the blender is off and
unplugged before installing or removing
attachments and parts.
Blades are sharp! Use extreme care when
handling.
Only hold blender in designated gripping
areas. See instruction details.
DO NOT reach or insert utensils into the
container while the blender is running.
Failure to follow these instructions can
result in broken bones, cuts, or other
serious injuries.
This Operation Manual provides the user with instructions to safely operate, clean, and
maintain the Immersion Blender. It is intended to facilitate use of the appliance (herinafter
referred to as "appliance"). It is mandatory that all users in charge of installing, commissioning,
operating, maintaining, repairing, or dismantling the machine read this manual and be properly
trained for all required responsibilities. This manual must be carefully kept at the workplace
and be readily available for the user to consult.
The applicable safety, hygiene, and environmental standards/regulations enforced in the
country where appliance is operated must always be applied during use.
SAVE THESE INSTRUCTIONS
Do not leave blender unattended when
29.
operating in continuous on mode.
Do not attempt to defeat interlock
30.
mechanisms.
If your appliance cord is fitted with a BS
31.
1363 Style Plug, it is provided with an
ASTA BS 1362 safety fuse. If you need a
replacement fuse carrier, it must replaced
with the same colour-coded carrier with the
same markings and amperage rating. Fuse
covers and carriers can be obtained from
approved service agents.
w WARNING
Electrical Shock Hazard
Do not use an extension cord.
Do not put motor housing, cord, or
plug in water or any other liquid.
Failure to follow these instructions can
result in death, fire, or electrical shock.
w WARNING
Entanglement Hazard
Keep clear of the rotating whisk.
Tie back long hair and loose clothing.
3