LEMANIA ENERGY GX2-Serie Bedienungsanleitung Seite 4

-Do not lift or carry the device by pulling on the power cables and keep the power cables
away from sources of heat, oil or sharp edges during charging and storage.
-If a power cable is damaged, do not use the charger and contact your distributor for
further assistance.
-When using or storing the charger, keep the charger out of reach of children or pets. The
charger must not be used by children or unskilled individuals.
-Store the charger in a dry, clean, well-ventilated environment and ensure cables are
stored safely and correctly.
-If possible do not use extension cables. Improper use of extension cables can result in
fire or electrical shocks. If use of an extension cable is absolutely necessary ensure that
the connectors are of the same shape, size and number of pins as the charger. Ensure
that the cable is in good condition, is not frayed or has exposed wiring and is of good
quality. For extension cable lengths up to 15m a 0.75mm² diameter cable is required, up to
30m - 1mm² and up to 60m - 1.5mm².
-Batteries contain lead and acid that can be dangerous in contact with skin or eyes
causing burns or blindness. Lead is dangerous during pregnancy.
-In case of contact with skin rinse the area immediately with water and neutralize the
acid with a mild alkaline solution such as milk. If exposed to electrolyte, rinse the area
with a strong stream of water. In all circumstances seek the assistance of a medical
professional.
-In case of contact with the eyes, rinse with clean water for at least 10 minutes while
waiting for the assistance of a medical professional.
-To prevent electrostatic discharges do not use the charger while wearing clothing made
of synthetic materials.
Before using the charger
1.Disconnect the battery from the vehicles electrical system. Ideally remove the battery
completely.
2.Ensure that the charger is disconnected from the mains.
3.Ensure that the acid level of the battery is correct according to the battery's specifica-
tions, the plates should be approximately 1cm below the acid level. If necessary, fill the
battery with the required amount of distilled water. For sealed batteries ensure that the
manufacturers specified charging instructions are followed.
Charging mode (GX2, GX5, GX10, GX15)
1.Connect the charger to the mains supply and press:
a.The 'Charge' button until the correct battery type is selected (GX10, GX15)
b.The 'Select' button until the correct battery type is selected (GX2, GX5)
2.Connect the positive (red) clamp to the positive (+) terminal of the battery then connect
the negative (black) clamp to the negative (-) terminal of the battery.
03
WARNING
INSTRUCTIONS