Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Software Installation
Setup-LightBurn
LightBurn
Step 1: Install LightBurn and run the program.
Step 2: Connect your PC to the Control board
with the included USB cable.
Step 3: Lightburn comes with a free 30 day
trial, after this you can purchase a licence key
from SainSmart at
https//www.sainsmart.com/products/lightburn-
gcode-license-key
Step 4: Click "Find My Laser" and start to
"Device Discovery Wizard"
You can use the laser engraving
software Lightburn or LaserGBRL
You can open this link or scan to
get the LightBurn GCode License
Key from SainSmart.
https://www.sainsmart.com/produ
cts/lightburn-gcode-license-key
and cutting
SCAN TO SHOP
21
Werbung
Inhaltsverzeichnis
