Operating Mode - Comfast CF-WR758AC Benutzerhandbuch

Operating mode

The software has four working modes, including relay mode, bridge mode, AP mode,
•
Routing mode (PPPoE dial-up, static IP, dynamic IP).
Bridge mode setting: Find and set in the advanced mode.
•
AP mode settings: Enter the software management page, click on the AP mode, in
•
order to facilitate management, this The IP address and default gateway entered
here should be the IP segment of the superior router, and the IP address cannot be
the same as the superior The router´s IP conflicts. After setting, the device´s WAN
port can access the external network through the setting IP address to access the
management device.
Note: Access to external network in AP mode, other mobile devices access the AP´s
wirelessly obtained IP address The network segment is allocated by the superior
device.
According to the default setting, it is not necessary to set the device-specific intranet
IP adress; In this case, you must manually set the IP address of the local network
card connected to the computer.
In AP mode, you can set 2.4G / 5.8G wireless SSID name and password. After setting,
•
set The prepared WAN port is connected to the external network; other mobile
devices connect the SSID name of the device through wireless, enter Connect to the
Internet with a password.
7