HOGERT HT2C502 Benutzerhandbuch Seite 4

Service address: GTV Sp. z o.o. Sp. K., ul. Przejazdowa 21, 05-800 Pruszków, Poland.
Work with the burner in clean places, away from flammable or greasy materials and use eye and hand protection. When the burner is
not to be used for a long time or for transport, the gas container must be removed.
OPERATION
Installation of the gas container
The burner is only suitable for use with gas containers according to EN 417 with a self-sealing threaded connection. Other models of
gas containers or containers that do not comply with EN 417 are not permitted.
Install the gas container outdoors or in well-ventilated areas. Keep a distance from fire or heat sources and bystanders. First close the
gas valve by turning the control knob clockwise in the direction „OFF". Make sure that the gasket is not damaged or worn. If any signs
of wear or damage are observed, the installation of a gas container is prohibited. Grasp the gas container and burner vertically in your
hand. Then screw the gas container clockwise to the burner valve seat until it stops. Check the tightness of the connection.
Warning! It is forbidden to use the burner with an improperly installed gas container. Make sure there are no gas leaks, preferably
with soapy water. It is forbidden to work with a burner in which a gas leakage was found.
Burner operation
Make sure there are no gas leaks before starting operation. To start the burner, turn the adjustment knob counterclockwise by 1/8th
turn. If a slight gas leakage is heard, it should be set on fire with an external fuse (not included in the kit) or matches. Adjust the flame
using the adjustment knob. After lighting the gas, it is advisable to wait about one minute until the burner heats up, which should be
in a vertical position. The flame of gas should be observed during this time. In the initial phase there may be a slight phenomenon of
flickering. If it does not go out spontaneously, extinguish the flame and contact the manufacturer. If the flame colour changes from blue
to orange, the burner must also be returned to an authorised service centre
Warning! Do not put down or heat the burner when it is lit.
Burner extinguishing
In order to extinguish the burner, turn the adjustment knob in the direction of the pointer movement until the resistance occurs. Then
the flame will go out spontaneously. Allow the burner to cool down completely.
Warning! It is forbidden to immerse or pour water over the burner for cooling purposes.
Disconnect gas container
The gas container can be dismantled at any time, even if it has not been completely emptied. To do this, turn the gas control knob
clockwise until it stops. Wait until all burner components have completely cooled down. Then unscrew the gas container by turning it
in the opposite direction to the direction of the pointer.
Maintenance
Clean the device with a damp cloth. Larger dirt should be cleaned with soapy water. Do not use abrasive cleaners. In case of any mal-
functions or contamination of the nozzle, stop using the burner and contact the manufacturer's service point. It is forbidden to modify
the burner and to clean the nozzle by yourself, especially with sharp objects.
Storage
Store the device in an upright position in a dry and well-ventilated place, inaccessible to unauthorised persons, especially children.
GTV Poland Sp. z o.o. Sp. K. hereby declares that the turbo gas burner type HT2C502 complies with the EU Regulation 2016/426. The
full text of the EU declaration of conformity is available at the following internet address: www.hoegert.com.pl
4
Adres producenta/ Adresse des Herstellers/ Manufacturer's Address/ Адрес производителя
GTV Poland Sp. z o.o. Sp. k., ul. Przejazdowa 21, 05-800 Pruszków