Destroying With 240/360 Crusher - intimus Auditor-Pro Betriebsanleitung

GB
8 Destroying with 240/360
Crusher / 360 Destroyer
Step 1: Media
„ Enter media serial number using scanner or input
manually
„ If desired, input INCIDENT NUMBER
„ Select YES or NO to capture after crush image
„ Select SSD if you are destroying an SSD using the
SSD-Destroyer
„ Press NEXT
Step 2: Before Crush Image Capture
„ Place media on imaging platform
„ Press OK to capture BEFORE CRUSH image
Step 3: Image Verification
„ Verify the clarity of the image
„ If acceptable, press ACCEPT and remove media
„ If the image is blurry, press REJECT and repeat
steps 1-2
18
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung
Step 4: Destroy Media
„ Place media into Crusher crush chamber and close
door
„ Press OK on Auditor-Pro
„ Press DESTROY on Crusher
„ When crush cycle is complete, open door
„ Remove media
„ If post crush image is not enabled, go to step 6
Step 5: Post Crush Image Capture
„ Place crushed media onto imaging platform
„ Press OK to capture POST CRUSH image
Step 6: Final Verification
„ Verify final image
„ If acceptable, press ACCEPT and remove media
„ If the image needs to be retaken, press RETAKE
94656 5 03/22