Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PPDCM80
• Disconnect leads from circuit before switching func- tions/ranges.
• Turn off power and discharge capacitors before mea- suring resistance,
capacitance, diodes or continuity.
• Do not connect the meter to a voltage source while in current, resistance,
capacitance, diode or continuity modes.
• Do not place the meter in any environment with high pressure, high temperature,
dust, explosive gas or vapor.
•
working properly, the protective equipment may be damaged; have the meter
serviced be- fore using.
• Do not use the meter with the battery cover not se- curely in place.
1.3 Safety Symbols
Note-Important safety information, refer to the instruction manual.
Application around and removal from UNINSULATED HAZARDOUS
LIVE conductors is permitted.
Caution, possibility of electric shock
Equipment protected throughout by double insula- tion or reinforced
insulation.
CSA STD C22.2 NO.
61010-1, 61010-2-032,61010-2-033
Complies with European (EU) safety standards
Earth (ground) TERMINAL
Direct current
Alternating current
CAT III: MEASUREMENT CATEGORY III is applicable to test and measuring
circuits connected to the distribution part of the building's low-voltage MAINS
installation.
- 4 -
EN
Werbung
Inhaltsverzeichnis
