Berger Powerstation BPS1000 Bedienungsanleitung Seite 19

GB
1) Power switch: Press the power switch lightly to initialise the dynamic percentage display.
The entire screen lights up and is displayed normally again after 1 second. At the same time,
the brightness of the LCD display is set to 100 %. At this time, the unit is on, lightly press
the power switch again, the brightness of the LCD changes to 50 % (lightly press the power
switch to adjust the brightness of the LCD after it is on), or then press and hold the switch for
1 second to turn off the unit and put it into sleep mode.
2) DC switch: After switching on the unit, press and hold the DC switch for 1 second, the
USB and 12 V output will be switched on, at the same time the LCD screen will display the
battery percentage, DC discharge time (h), DC discharge power and DC OUT icon (shown as
Display_1). After switching on, lightly press DC switch, switch the real-time battery percen-
tage/battery real-time voltage mode. Press and hold DC switch for 1 second to turn off USB
and 12V output.
Display_1
3) AC switch: After switching on, press and hold the AC switch for 1 second, the AC output
is switched on, at the same time the LCD screen shows the percentage of battery capacity /
battery voltage, AC discharge time (H), AC discharge power, percentage of AC output power
„AC OUT" icon (shown as Display_2). After the AC output is switched on, press the AC
switch lightly to switch the mode AC discharge power + AC discharge time / AC discharge
voltage + PF value (see picture Display_3). Press and hold the AC switch for 1 second, the AC
output switches off.
Display_2
19