TIE TBT1 Benutzerhandbuch Seite 3

We strongly recommend that you fully charge the
adapter before using it for the first time. It takes about
3 hours to fully charge the adapter for the first time.
1. Charge with computer: connect the micro USB
cable to the adapter power connector and the
standard USB plug to computers USB port.
2. Using an electrical outlet to charge: connect the
micro USB cable to the adapter and the standard
USB plug to a DC 5V adapter.
3. Indicator status:
a. RED = charging
b. OFF = charge completed
Note:
1. When the battery of the adapter is almost empty,
the LED flashes red and a beep sounds. Please
charge the adapter.
2. If you have not used the adapter for a few months,
the LED may not turn red at first when charging. It
may take 15-35 minutes for the LED to turn red. We
recommend fully charging the adapter at least once
every two months.
RECEIVER (RX MODE), SWITCH ON / OFF
Please set the TX/RX switch to the RX position before
starting the TBT1. The TX or RX mode can no longer
be changed during operation.
CHARGING THE TBT1
2