Instructions For Proper Use - Compass ORCA Bedienungsanleitung

item 02 122

Instructions for proper use:

ź
Before installing the carrier, make sure the tow ball is properly cleaned.
ź
Check that the exhaust is at sufficient distance from the bicycle tyres and safety straps. Hot air from the
exhaust could damage the bicycle or carrier.
ź
If your vehicle is equipped with an automatic trunk door opening system, disable this function whenever
you use the carrier. Open the trunk door manually only.
ź
When loading bicycles on the carrier, remove all free parts (tool bags, child seats, pumps, etc.)
ź
Always place the largest / heaviest bicycle closest to the vehicle and then place smaller bicycles.
ź
The user is responsible for checking regularely, that all components, straps, screws are securely tighte-
ned, thus ensuring safe operation.
ź
It is possible that you may use extra protection, for avoiding scratches to bicycles and trunk door.
Safety of use:
ź
Make sure, the lights are working properly before leaving.
ź
The carrier increases the overall length of the vehicle and the bicycles on it can also increase the overall
width and height of the vehicle. Keep this in mind when you drive through a narrowed or reduced space,
and especially when you are parking (reverse).
ź
Any cargo exceeding the dimensions of the vehicle must comply with the applicable regulations and be
properly secured.
ź
Load on the carrier affects driving. Do not exceed the permitted speed limit. Do not exceed 120 km/h (75
mph).
ź
Drive slowly over slowing bumps. Obey the speed limits and adjust your speed to road conditions.
ź
Driving on paved roads is not recommended, it can cause damage to your vehicle, tow bar, carrier or
bicycles.
ź
If you run on a protrusion or potholes on the road, stop the vehicle and check the bicycles and the carrier.
If you find any damage, remove bicycles and do not use the carrier any longer.
ź
Ensure that there is a safe distance between bicycles and ground, especially when entering the road.
Maintenance:
ź
Regularely check the carrier, if it wears marks of excesive use, rust or damage on the material.
ź
Do not use the carrier, if there is damage on any of parts. Contact authorized workshop about repairing
those parts, so u can use the carrier again.
ź
Dismount the carrier before entering the car wash.
ź
To keep the product in the best condition, it is recommended to dismount the product from the vehicle
when not in use.
ź
Beware, the product is not designed to withstand extreme weather conditions, especially the seaside
climate.
ź
Lubricate the screws to prevent rust.
Important warning:
ź
Carefully wipe the tow ball of grease before installing the carrier.
ź
It is necessary to tighten the nut on the ball of the towing device so that the entire carrier is firmly in place
and does not move. Otherwise, it could get loosed by itself while driving.
e
3