1- General Requirements And Installation; General Notes; Product Label And Rating Plate - Kohler VERSO50 Betriebsanleitung

1- GENERAL REQUIREMENTS AND INSTALLATION

1- 1 General notes

WARNING!
• Carefully read the manual before the installation or use.
• This equipment is to be installed by qualified personnel, complying to current standards, to avoid damages or safety hazards.
• Before any maintenance operation on the device, remove all the voltages from measuring and supply inputs.
• Products illustrated herein are subject to alteration and changes without prior notice.
• Technical data and descriptions in the documentation are accurate, to the best of our knowledge, but no liabilities for errors, omissions or
contingencies arising there from are accepted.
• A circuit breaker must be included in the electrical installation of the building. It must be installed close by the equipment and within easy reach
of the operator. It must be marked as the disconnecting device of the equipment: IEC /EN 61010-1 § 6.12.2.1.
• Clean the instrument with a soft dry cloth; do not use abrasives, liquid detergents or solvents.

1- 2 Product Label and Rating plate

General identifications of each unit are traced on the plate below and placed on the controller.
VERSO 50_v1.0.27_EN 33502027401_3_1 page 3/24