GGM Abbey.HS27.221.E Montageanleitung Seite 9

STEP 4
4-1. Table Installation
Slide fastening nut down the pole with the rounded side faced
downwards.
4-2. Next, slide the tightening spacer down the pole with the smaller
side facing downwards. Put the table on the pole with the metallic side
facing up.
STEP 5
5-1. Insert the screw coupler on the pole, inserting it through the middle
of the table on the pole. Thread the tightening spacer on the bottom of the
table counterclockwise onto the screw coupler.
5-2. Tighten securely to hold the table to the screw coupler. Thread the
fastening nut counterclockwise. Tighten securely to lock in place. Loosen
the fastening nut to adjust the position of the table on the pole.
STEP 6
6-1. Remove the 4 bolts from the burner.
6-2. Put the gas hose through into the pole.
6-3. Fix the burner unit to the pole by the 4 bolts.
- 4 -
STEP 4
Fastening nut
Table
Tightening
spacer
STEP 5
Screw Coupler
STEP 6
Bolt