Hardi BRE 18 Bedienungsanleitung Seite 13

6 - RESTARTING AFTER WINTERING:
1. Recharge the sprayer battery.
2. Rinse the circuit by spraying 2 to 3 liters of clean
water, check that there are no leak at each
junction.
3. The sprayer is ready for use. See chapter 4.
7 - NOZZLE REPLACEMENT OR
DISASSEMBLING DURING SPRAYER USE:
1. During nozzle disassembling, the user shall
imperatively keep his personal safety equipment
(gloves, goggles...).
2. Unscrew the nozzle of the nozzle support and rinse
the nozzle immediately.
3. Be careful, the liquid contained in the tube could
spill. Don't press the trigger.
4. Screw the new nozzle or the clean nozzle.
5. Use only the HARDI nozzle.
Nozzle
   
8 - USABLE NOZZLES

"ELECTRIC" is characterised by an
operation at CONSTANT PRESSURE, regardless of
the battery charge level. The FLOW RATE and
PRESSURE values are selected EXCLUSIVELY
using the Selector button
% 

#$
!
# $&
"
 $&
"
Recommended
Impossible
Every time the nozzle is changed, you
must switch your machine off and then
on again so that it recalibrates itself.
(Fig. ).
 

13