SL mono Bedienungsanleitung Seite 10

Operation
Light sensor :
If the light sensor is activated, the lamp will switch between
daytime running light and low beam automatically, depending
to the ambient light. If low beam is activated you can switch
to a dimmed low beam by pushing the button once. The light
sensor is still active. Note: The sensor controlled switch from
night- to daytime running light occurs with a delay of 16 sec.
If the light sensor is deactivated, you can manually switch
through the dim levels by pushing the button once.
1. Daytime running light, 2. dimmed low beam, 3. low beam
Colours of the button on the lamphead:
The button does'nt light: The lamp is switched off or daytime
running light is activated.
The button lights green: Dimmed low beam is activated.
The button lights blue: Low beam is activated.
Capacity indicator:
After turning the lamp on, the button will show the capacity
for aprox. 2 seconds.
100 - 76% capacity = lights green
75 - 51% capacity = blinks green
50 - 26% capacity = lights red
25 - 0% capacity = blinks red (needs to be charged)
Battery warning at the lamphead in operation:
1. Warning, low capacity remaining.
Button lights red:
2. Warning, very low capacity remai-
Button blinks red:
ning, charge immediately. Only daytime
running light remaining.
3. Warning, Attention: beam pattern no
Button blinks
longer conforms to the StVZO. In order
red/blue:
to be able to continue using the lamp,
confirmation via the button is required.
Operation