MSI K9NG Neo-V Serie Bedienungsanleitung Seite 12

Memory
The mainboard provides two 240-pin unbuffered DDR II 667 / 800 DIMM slots, and supports the
memory size up to 2GB. To operate properly, at least one memory module must be installed.
Install at least one memory module on the slots. Memory modules can be installed on the slots in
any order. You can install either single- or double-sided modules to meet your own needs.
Installing DDR II Modules
The memory module has only one Notch on the center of module. The memory module will only
fit in the right orientation.
1. Insert the memory module vertically into the DIMM slot. Then push it in until the golden finger
on the memory module is deeply inserted in the DIMM slot.
2. The plastic clip at each side of the DIMM slot will automatically close.
ATX 24-Pin Power Connector: ATX1
This connector allows you to connect an ATX 24-pin power supply. To
connect the ATX 24-pin power supply, make sure the plug of the power
supply is inserted in the proper orientation and the pins are aligned.
Then push down the power supply firmly into the connector.
You may use the 20-pin ATX power supply as you like. If you'd like to
use the 20-pin ATX power supply, please plug your power supply along
with pin 1 & pin 13. There is also a foolproof design on pin 11, 12, 23 &
24 to avoid wrong installation.
ATX 12V Power Connector: PWRCONN1
This 12V power connector is used to provide power to the CPU.
Floppy Disk Drive Connector: FDD1
The mainboard provides a standard floppy disk drive connector that supports 360K,
720K, 1.2M, 1.44M and 2.88M floppy disk types.
IDE Connector: IDE1/ IDE2
The mainboard has dual Ultra DMA 33/ 66/ 100/ 133 controller that provides PIO mode
0~4, Bus Master, and Ultra DMA 33/ 66/ 100/ 133 function. You can connect up to four
hard disk drives, CD-ROM, 120MB Floppy and other devices.
The first hard drive should always be connected to IDE1. IDE1 can connect a Master and
a Slave drive. You must configure second hard drive to Slave mode by setting the jumper
accordingly.
All manuals and user guides at all-guides.com
Volt Notch
GND
12V
6
13
1
+3.3V +3.3V
-12V +3.3V
GND GND
PS-ON# +5V
GND GND
GND +5V
GND GND
Res PWR OK
+5V 5VSB
+5V +12V
+5V +12V
GND NC
24 12
2 1
GND
12V
4 3