Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH - CODEBOX key safes with electronic lock – 27 or 72 hooks
Preparation
Put in 4 AA batteries and the display shows "-SL-". The master code and user code has been pre-programmed with the
following digits:
• User code: 168
• Master code: 888888
It is advisable to change the pre-programmed user and master code as soon as possible!
Programming the user code
• At any time you can clear entered digits by pressing *.
• With the door open, press keys **1. The display will now show "-PROG-" "-CODE-".
• Enter your new user code (3 to 6 digits) and press #. The display will now show "-GOOD-" and you will hear two beeps.
The user code has been successfully programmed.
Programming the master code
• At any time you can clear entered digits by pressing *.
• With the door open, press keys **2. The display will now show "-PROG-" "-CODE-".
• Enter your new master code (3 to 6 digits) and press #. The display will now show "-GOOD-" and you will hear two
beeps. The master code has been successfully programmed.
Opening the door
Enter the user code or master code and press #. If the code is valid, the door will now open automatically. The display will
show "OPENED".
Closing the door
Press # to close the door. The display will show "CLOSED".
Hidden code entry
Press * before entering your code. The display will hide the code entered and will show "-" instead.
Anti-manipulation function
Three consecutive wrong code entries will activate the auto-lock system and the safe will lock for 5 minutes while the
display shows "HOLDX" (X stands for the remaining minutes). After expiry of the 5 minute locking period you may try to
open the safe again.
Notes
• When the safe door is accidentally left open, an alarm will beep every 5 seconds.
• Press # with the door closed to check the batteries' voltage. If the display shows "HI-BAT" it means the batteries have
high voltage. If the display shows "LO-BAT" it means the batteries have low voltage and should be replaced as soon as
possible.
• In case of malfunction, you can always open the lock with the emergency key or emergency power.
• When the bolts get stuck, the display shows "E-BAR".
• When a wrong code is entered, the display shows "ERROR 1", "ERROR 2" or "ERROR 3".
NEDERLANDS - CODEBOX sleutelkluizen met elektronisch slot – 27 of 72 haken
Voorbereiding
Plaats 4 AA batterijen. De display toont "-SL-". De mastercode en gebruikerscode zijn vooraf geprogrammeerd met een
standaard code:
• Gebruikerscode: 168
• Master code: 888888
Het is raadzaam om the standaard gebruikerscode en mastercode zo snel mogelijk te wijzigen!
Gebruikerscode programmeren
• Een ingegeven cijfer kunt u altijd ongedaan maken door * in te toetsen.
• Toets **1 in met de deur geopend. The display toont nu "-PROG-" "-CODE-".
• Toets uw nieuwe gebruikerscode in (3 tot 6 cijfers) en toets #. De display toont nu "-GOOD-" en u hoort twee piepjes.
2
Werbung
