Removal And Disposal - HEIDENHAIN VT 121 Betriebsanleitung

6.6 Resuming operation
When operation is resumed, e.g. when the product
is reinstalled after repair or when it is remounted, the
same measures and personnel requirements apply as for
mounting and installing the product.
Further information: "Mounting", Page 38
"Installation", Page 39
Further information:
The operating company must ensure safe resumption
of operation and assign authorized and appropriately
qualified personnel to the task.
Further information: "Obligations of the operating
company", Page 33
46
7

Removal and disposal

7.1 Overview
This chapter contains information and environmental
protection specifications that must be observed for
correct disassembly and disposal of the device.
7.2 Removal
The following steps must be performed only
by qualified personnel.
Further information:
Page 33
Depending on the connected peripherals, the product may
need to be removed by an electrical specialist.
In addition, the same safety precautions that apply to the
mounting and installation of the respective components
must be taken.
"General safety precautions",
Further information:
Page 34 and following
Removing the product
To remove the product, follow the installation and
mounting steps in the reverse order.
"Mounting", Page 38
Further information:
Further information: "Installation", Page 39
HEIDENHAIN | VT 121 | Operating Instructions | 7/2020
"Personnel qualification",