Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
16
INSTALLATION
•
Open the four clips in the direction of the arrow (A) to separate the cover
from the rest of the casing (B).
•
Hold the housing firmly while carefully pulling up the cover on the valve to
release it (C)
•
If you do not want to use cotton filters, you can insert alternative filter
materials in the filter housing. In any case, proceed as shown in figure D or
in the section "Components" and layer any filter media from fine (bottom)
to coarse (top).
•
Close the housing again by fixing the cover with the clips (E)
•
Fix the valves at the inlet and outlet. Make sure that the sealing ring
(circles in figure F) is securely seated in the internal thread of the valve
outlets. To avoid overtightening the threads, do not use excessive force
when screwing on. When starting up the filter, be sure to check whether
water is leaking at any point and adjust accordingly if this is the case.
Werbung
Inhaltsverzeichnis
