Gallet Maris BAC 927 Bedienungsanleitung Seite 28

– You may put the container for liquids (max. weight 0.5 kg) on the scales before
turning it on. If you do so, the scale will turn on automatically when reaching 0.
– T he results of measuring the volume of milk differ from measuring the volume of water
due to their density. Milk has subtly higher density than water (approx. 1, 028 x).
„ZERO" OR „TARE" FUNCTION
To weigh different loads consecutively without removing loads from the scale. Put first
Load on the scale, get weight reading. Press A5
before adding next load. Add another item and the display will read the added weight. You
can repeat this operation. If all products are taken away from the weighing plate,a negative
value will appear on the display.
Note 1: „ZERO" function
When total sum of all loads on scale ≤ 200 g, LCD will show „0" each
time is pressed. Icon „O" will show on upper left corner of LCD,
indicating „ZERO" function is active. Max. weight capacity remains
unchanged.
Note 2: „TARE" function
Exceeding loading capacity of the scale
Maximum weight for a product weighing is 5 kg. The display will show Err Error message
in case the weight of the product on the plate exceeds 5 kg. It means the product weight
exceeds the loading capacity of the scale.
Remove the excessive weight product from the scales to avoid damage to the appliance.
Note
If the total weight is > 200 g, the display (after pressing the
button) will show the icon "T" in the upper left corner of the display,
which indicates the activity of the „TARE" mode. By pressing the
button in this mode, you will display the total amount of
weights/volumes of all items. If you wish to continue with TARE
weighing, just press the
The maximum capacity will decrease by the total weight of all
items.
Note:
After removing all items from the weighing surface, the display will
show the total number of weights/volumes with the "-" mark.
Auto shut off
Auto shut-off occurs if display shows ‚0' or shows the same weight
reading for 120 sec.
Attention
button to reset the LCD reading to „0"
button again to reset the display to 0.
28 / 46
i
!