Orbitalum MRA Originalbetriebsanleitung Und Ersatzteilliste Seite 28

eNGLISH
Operation
3. Add tension to the chain with even levering motions of at least 90° until the cutting wheels press into the tube wall.
IMPORTANT!
NOTe!
X The tube has now been cut through completely.
28
ORBITALUM TOOLS GmbH D-78224 Singen www.orbitalum.com
• When adding tension avoid left/right motions as these can cause damage to the
cutting chains.
• Only add tension to the cutting chain during a levering motion. The most effective
method is to add tension during a levering motion, perform the return motion, then
adjust again with the next movement.
• To make the cutting process easier, cutting oil can be used.
• If the clamping shells open on one side during cutting because the tube was cut
through on this side first, the clamping shells clamp must be placed at this position.
Clamping shells clamp
MRA
[REV. 20191205] OC_MRA_BA_790008761_00__INH-02_EN