Use Of The Microphones - auna PRO VHF-4 Bedienungsanleitung

1. Connect the mains cable to a socket and ensure that the power supply
is 220 V~ / 50 Hz.
2. Switch the device on. The operating light comes on.
3. Unplug antennas A and B (for article 10030865, 10030866 only one
antenna). Align the antennas at a right angle with the receiver.
4. Connect to the audio output.
5. Switching on the microphone. The operating light comes on.

USE OF THE MICROPHONES

1. Unscrew the battery compartment housing in an anti-clockwise
direction. Insert a 9 V block battery.
2. Set the switch to the ON position. The signal light lights up. If the light
does not come on, check the polarity of the inserted battery or check
the battery charge level.
Note: The standby function is between ON and OFF on the on/off
switch. In standby status, the microphone is still powered, but it does not
record sound.
3. Remove the battery from the microphone if you are not using the
system for a longer period of time.
grid
on off
LED
standby case battery
compartment cover
EN
17