Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
g. Running status checking
1) Press"
" for 5 seconds, a sound of "di" can be heard and it will enter into running status checking"
2) at this time, the display alternately shows status point "C0" and its corresponding value.
3) Change status pointer through"
4) Press "
" can quit "running status checking" mode
5) Running status checking table
Symbol
C0
C1
C2
C3
C4
C5
C6
C9
C10
F. Testing
1. Inspect heat pump before use
a.
The ventilating device and outlets are operating adequately and are not obstructed.
b.
It's prohibited to install refrigeration pipe or components in corrosive environment.
c.
Inspect the electric wiring on basis of the electric wiring diagram and earthing connection.
d.
Double confirm the main machine power switch should be off.
e.
Inspect the temperature setting.
f.
Inspect the air inlet and outlet.
2. Leakage detection notice and method
other detector using a naked flame) shall not be used.
c.
Leakage detection fluids can be applied with most refrigerants but the use of detergents containing chlorine
shall be avoided as chlorine may react with the refrigerant and corrode the copper pipe.
d.
Vacuumize completely before welding. Welding can only be carried out by professional personnel in service
center.
e.
Please stop using while gas leakage occur, and contact professional personnel in service center.
" and "
Content
Inlet water temp
Outlet water temp
Ambient temp
Exhaust temp
Outer coil pipe temp
Gas return temp
Inner coil pipe tem
Radiator temp
Electronic expansion valve opening
a.
Leakage checking is prohibited in closed area.
b.
The ignition source is prohibited during the leakage inspection. A halide torch (or any
", the corresponding value also changes with it.
Unit
℃
℃
℃
℃
℃
℃
℃
℃
P
13
Werbung
Inhaltsverzeichnis
