Eternico AET-MS460SB Bedienungsanleitung Seite 8

INSTRUCTIONS
2.4 G operating mode selection
Installation
Insert the USB receiver into the USB-A port of your computer.
The mouse is installed automatically so you can control the mouse quickly and comfortably.
Bluetooth operating mode selection
If you will be using a wireless mouse in Bluetooth operating mode, you must remove the USB
receiver.
1. Press the operating mode selection button repeatedly to select the BT1 (Bluetooth 1) or
BT2 (Bluetooth 2) mode. The LED indicator of the selected mode lights up.
2. Press and hold the operating mode selection button for more than 3 seconds to enter
the pairing process. The LED indicator of the selected mode will flash. The pairing time
is 3 minutes.
3. On your computer, click "Add Device - Bluetooth" to start the device search.
4. If the pairing was successful, the LED indicator of the selected operating mode will go out
after approx. 2 seconds and the mouse cursor will appear on the display.
CLEANING
Keep the wireless mouse clean. Turn the switch to the "OFF" position before cleaning.
Use only a dry, clean cloth for cleaning. Do not use harsh cleaners, solvents, gasoline or other
similar substances. Never wash the wireless mouse with water and do not immerse it in water.
If you will not be using the wireless mouse for an extended period of time, set the power
switch to "OFF".
8 ENGLISH