Before The First Use; Cleaning And Storage - Rondell Rde-1151 Die Betriebsanweisung

list given in the warranty certificate and on the website
www.rondell.ru.
•
To avoid damages, transport the unit in the original
package only.
•
Keep the unit out of reach of children and disabled
persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE ONLY.
ITS COMMERCIAL USAGE AND USAGE IN PRODUCTION
AREAS AND WORK SPACES IS PROHIBITED.

BEFORE THE FIRST USE

After unit transportation or storage at low tempera-
ture keep it for at least three hours at room tempera-
ture before switching on.
– Unpack the coffee grinder and remove any pack-
aging and advertising materials that can prevent its
operation.
– Before using the unit, make sure that your home mains
voltage corresponds to the unit operating voltage.
– Remove the ground coffee container (1) with the lid (2)
pulling it towards you.
– Remove the coffee bean container lid (7).
– Remove the upper millstone (9) turning it clockwise in
the «unlock» direction and wipe it.
– Carefully wipe the lower millstone.
– Wash all removable parts (1, 2, 7) with warm water and
a neutral detergent, then rinse and dry thoroughly.
– Clean the coffee grinder body (12) with a soft, slightly
damp cloth, and then wipe it dry.
– Install the upper millstone (9) back to its place turn-
ing it counterclockwise in the «lock» direction until
bumping.
– Put the lid (7) on the coffee bean container (8).
– Close the ground coffee container (1) with the lid (2)
and install it to its place until the lock (3) clicking.
USING THE COFFEE GRINDER
The maximal continuous operation time is 1 grinding
cycle with a 3-5 minute subsequent break.
– Unwind the power cord completely.
– Make sure that all removable parts are installed prop-
erly.
– Open the lid (7) and put the coffee beans into the con-
tainer (8).
Note:
– Do not put more than 250 g coffee beans into the con-
tainer (8).
– Cover the container (8) with the lid (7).
– Turn the control knob (11) to select the required grind-
ing degree:
«COARSE» – coarse grinding for brewing coffee in
the coffee pot;
«MEDIUM» – medium grinding for drip coffee makers;
«FINE» – grinding degree for pump-driven coffee
makers.
Note: - when selecting the grinding degree you can set
the knob (11) to any position within the scale.
– Insert the power plug into the mains socket.
– Set the required amount of ground coffee by turning the
knob (5), the scale (4) is marked in "cups" from 2 to 12.
– Switch the unit on by pressing the button (6) «
Note:
– before switching the unit on, make sure that the con-
tainers (1 and 8) are covered with the lids (2 and 7),
and the container (1) is correctly installed, otherwise
the coffee grinder will not switch on;
– if during the coffee grinder operation the coffee beans
do not reach the millstones, it is recommended to
slightly tilt the coffee grinder or shake it carefully.
– The coffee grinder is switched off automatically.
– If during the operation the coffee bean container (8)
becomes empty or if you need to switch the coffee
grinder off immediately, press the on/off button (6)
« » again.
– Unplug the unit after operation.
– For the best taste of the ready drink grind only nec-
essary amount of coffee beans right before the cof-
fee making.
– To prevent the flavour degradation of ground coffee
keep the fresh-ground coffee in tightly closed jars or
in a vacuum package.

CLEANING AND STORAGE

– Unplug the coffee grinder before cleaning.
– Disassemble the coffee grinder as described in the
chapter "BEFORE THE FIRST USE".
– Wash all removable parts (1, 2, 7) with warm water and
a neutral detergent, then rinse and dry.
– Do not wash the removable parts in a dishwasher.
– Remove the upper millstone (9) turning it clockwise
«unlock».
– You can clean the inner and upper millstones with a
brush.
– Install the upper millstone (9) turning it counterclock-
wise «lock».
– Wipe the coffee grinder body (12) with a slightly damp
cloth, and then wipe it dry.
5
ENGLISH
».