Technical Specifications - VONROC PS504DC Originalbetriebsanleitung

EN
a requirement for the proper use of the Pressure
Sprayer.
Warning!
1. Do not use guns for spraying flammable materi-
als.
2. Be aware of any hazards presented by the ma-
terial being sprayed and instruction to consult
the markings on the container or the informati-
on supplied by the manufacturer of the material
to be sprayed.
3. Do not spray any material where the hazard is
not known.
4. Do not clean guns with flammable solvents.
According to the Plant Protection Law as well as
1
the Detergents and Cleaning Agents Law, only ap-
proved agents may be used (authorised specialist
dealers).

TECHNICAL SPECIFICATIONS

Model No.
Max Capacity
Voltage
USB connection
Spray tube length (including
sprayhandle)
Working time
Charging time
Pressure output
Max water operating tempe-
ture
Sound pressure (Lpa)
Acoustic power (Lwa)
Vibration
Vibration level
The declared vibration total value has been measu-
red in accordance with a standard test method EN
60745-1 & EN50580 and may be used for compa-
ring one tool with another; The declared vibration
total value may also be used in a preliminary
assessment of exposure.
• The vibration emission during actual use of the
power tool can differ from the declared total
8
PS504DC
5L
4V
Micro USB Type B
15-50CM
2 hours
2 hours
0.3L/Min
60 °C
52.8 + 3 dB(A)
63,8 + 3 dB(A)
0.205 + 1.5 m/s2
value depending on the ways in which the tool
is used.
• Need to identify safety measures to protect the
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such
as the times when the tool is switched off and
when it is running idle in addition to the trigger
time).
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-4.
1. Sprayer
2. Nozzle closing nut
3. Short nozzle
4. Long nozzle
5. Hose
6. Tank
7. Tank handle
8. Tank ring
9. Relief valve
10. Carrying strap
11. Charging cable (included)
12. Charging indication light
13. On/off switch
14. Hose filter
15. Battery indication light
16. Nozzle storage
17. Liquid level indicator
3. ASSEMBLY
Nozzles (Fig. B)
With first use the short nozzle (3) is assembled on
the sprayer (1).
• Remove the nozzle closing nut (2)
• Remove and replace the short (3) or long nozzle
(4)
• Place the nozzle closing nut (2) and tighten by
hand.
Check if the hose (5) is still well connected
to the sprayer (1) and to the tank ring (8), if
necessary tighten the nuts by hand.
Carrying strap
• Attach the carrying strap to the tank.
WWW.VONROC.COM