Quick Connect - FS AP-N303 Schnellstartanleitung

System Mode
NOTE: The AP works in Fit AP Mode by default.
Configuring the AP via the Console Port (FAT AP Mode)
Step 1: Connect a computer to the AP's console port using the console cable.
Step 2: Start the terminal simulation software such as "HyperTerminal" on the computer.
Step 3: Set the parameters of the "HyperTerminal": 9600 bits per second, 8 data bits, no parity,
1 stop bit and no flow control.

Quick Connect

Protocol:
The port may be manually entered or selected from the list.
Port:
Baud rate:
Data bits:
Parity:
Stop bits:
Name of pipe:
Step 4: After setting the parameters, click "Connect" to enter. And then enter the password
("admin" by default).
10
Current Mode: Fit AP Mode
Internet
AC
POE SW
AP
CLLENT
AP
Fit AP Mode
NOTE: The device restarts after mode switch. please wait for a minute.
Serial
COM3
9600
8
None
1
Show quick connect on startup
Internet
ROUTER
POE SW
AP
CLLENT
Fit AP Mode
Flow Control
DTR/DSR
RTS/CTS
XON/XOFF
Save session
Open in a tab
Connect Connect Cancel
x
x