Important Warnings; Filter Installation - Zelmer ZPU5500 Benutzerhandbuch

PL EN

IMPORTANT WARNINGS

This appliance is designed for home use and should never be used for commercial or industrial use under any
circumstances. Any incorrect use or improper handling of the product shall render the warranty null and void.
Prior to plugging in the product, check that your mains voltage is the same as the one indicated on the product
label.
The mains connection cable must not be tangled or wrapped around the product during use.
Do not use the device, or connect and disconnect to the supply mains with the hands and / or feet wet.
Do not pull on the connection cord in order to unplug it or use it as a handle.
This product cannot replace normal ventilation, daily dust collection or oil pumping when cooking.
To prevent plastic parts from melting or catching on fire, do not place the product near heating appliances.
Ensure both the filter and its cover is properly installed before using.
Product must be used on a level and stable surface.
Do not use outdoors.
Unplug the product immediately from the mains in the event of any breakdown or damage and contact an
official technical support service. In order to prevent any risk of danger, do not open the device.
Only qualified technical personnel from the brand´s Official technical support service may carry out repairs
or procedures on the device.
B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals or objects, for the
non-observance of these warnings.
INSTRUCTIONS FOR USE
Before use:
Make sure that the packaging from the filter has been removed (following the steps for installing filter).

FILTER INSTALLATION

Ensure the appliance is unplugged before removing or installing the filter.
When the power indicator keeps flashing in red, the filter should be replaced.
Please wipe the dust on the filter regularly, do not wash or use it repeatedly.
Please use the filter specially designed for this product.
Steps for installing filter (fig.1)
Unplug the power socket of the machine before replacing or installing the filter.
1. Invert the machine and rotate the base along the direction marked "Open".
2. Take out the filter from the appliance.
3. Remove the packaging filter into the item.
4. Then install the filter into the machine.
5. Then install the base, rotate and tighten the base along the direction marked "Close".
Note: Please press the power button for 7 s to reset after installing a new filter, and the anion indicator light
will stop flashing.
USE
When connect the appliance to the mains, the buzzer will ring for 1 second.
9