Button Function - Konix Drakkar Aurora Bedienungsanleitung

INSTALLATION
- Remove the protective film and stick the adhesive strip 4 to a smooth, clean, and dry
surface.
- Connect the LED strip 1 to the USB connector (fig. 1).
OPERATION
- Ensure that the infrared diode 2 of the LED controller is not covered and can be
controlled with the remote control 3 without obstructions (fig. 2).
- Remove the safety strip in the battery compartment before switching the LED strip
on.
- Remote control button functions (fig. 3)
Button Function
1 Increase brightness.
2 Decrease brightness.
3 Switch the LED strip off.
4 Switch the LED strip on.
5 Rapid colour change without blending.
6 Slow colour slowly without blending.
7 Slow colour slowly without blending.
8 Rapid colour change with blending.
9-24 Select the desired colour.
SHORTENING THE LED STRIP
- Disconnect the LED strip 1 from the USB connector before performing any work on it.
- Shorten the LED strip 1 to the desired length by trimming the last section in the line.
- The cutting point is in the exact middle between the positive and negative poles, and
is marked with a white line and a scissors symbol.
- Cover the open end of the LED strip 1 with the adhesive strip 4 before use (fig.4).
A
5