Before The First Use; Intended Use; Explanation Of Symbols - Rollei Lumis Glow RGB Anleitung

Before the First Use

Before using the device for the first time, read the operating
instructions and the safety instructions carefully.
Keep the operating instructions together with the device for later
use. If other people use this device, please make these instructions
available to them. If you pass the device on to third parties, these
instructions belong to the device and must be supplied with it.

Intended Use

This unit is designed for use as photo and video lighting only.
It must not be used for other purposes and in particular not for
domestic room lighting.

Explanation of Symbols

The following symbols are used in this manual, on the LED light,
the power supply unit or on the packaging.
Products marked with this symbol comply with all relevant
community regulations of the European Economic Area.
Products marked with this symbol are operated with direct
current.
What's in the Box
– Rollei Lumis Glow RGB
– USB-C cable
– Remote control
– Transport bag
– Hand strap
ENGLISH
Overview
1 LC display
2
Mode button
3 Plus button
4
USB-C connector
5
Hand strap attachment
6 1/4" tripod thread
7
Select button
8 On / Off button
9
Minus button
Operation
– Press and hold the On/Off button [8] for three seconds to switch
the unit on/off.
– Press the Mode button [2] to select between the different
modes. There are five different modes.
Mode 1:
Select from seven different scenes, press the Plus / Minus buttons
[3 / 9] to switch between scenes.
Possible scenes:
– Romantic light
– Birthday candle light
– Pink ambience light
– Forest light
– Ocean blue light
– Police light
– Flash light
After selecting, press the Select button [7] to adjust the brightness
between 5 – 100% in 1% steps using the Plus / Minus buttons [3 / 9].
Mode 2:
Seven RGB colours alternate at a slow interval. Change the inter-
val speed with the Plus / Minus buttons [3 / 9].
After selection, press the Select button [7] to adjust the brightness
with the Plus / Minus buttons [3 / 9] between 5 – 100% in 1% steps.
Mode 3:
In this mode you can adjust the intensity of the individual main co-
lours red, green and blue separately. The respective selected colour is
highlighted. To change the intensity, press the Plus / Minus buttons
[3 / 9]. To move to the next colour, press the Select button [7].
1
2 7
3 9
4
5
6
5
8