Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connecting your AC110 to the mains (Optional)
Pairing your AC110 with the AMPLICALL receivers
The AC110 can work on its own, it will amplify the ringer and will flash
when you receive a call. You also have the possibility to register your
TM
AMPLICALL
receivers will receive the information from the AMPLICALL
ring and flash as well.
Enter pairing mode for the AMPLICALL receivers.
1.Press & hold the LEARNING button (●) for 3 seconds. The LED in
zone icon #1 will flash
2.Press the LEARNING button (●) again to move to the zone icon
you wish to pair the AC110 with.
Press the melody selection (
melodies. Once you hear a melody you like, do not press any
button during the melody.
3.Press once the bell button of the AC110 to pair.
4.If successful, the AMPLICALL receivers will generate two short
tones.
Even if your AMPLICALL
into the mains, you must insert batteries,
otherwise your device will send a low battery
signal to your receiver.
Those batteries will however only work as
backup batteries in the event of a power
failure.
Connect the type C USB power cable to
the DC input connector.
110 with the AMPLICALL receivers. If paired, the
) button to scroll through the
4
TM
110 is plugged
TM
110 and
Werbung
Inhaltsverzeichnis
