Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
Translation from original operating
manual
Refrigerator for bottles
Dear Customer,
Before using the appliance, read the
following instructions carefully and keep
this manual for future reference. The
appliance must only be used by persons
familiar with these instructions.
Connection to the mains supply
∙ The appliance should only be
connected to an earthed socket
installed in accordance with the
regulations. Make sure that the
supply voltage corresponds with the
voltage marked on the rating label.
This product complies with all binding
CE labelling directives (see EC-
Declaration of Conformity at the end of
the manual).
∙ Do not operate this unit by means of
a transformer or, together with other
electrical appliances, by means of an
extension cable.
∙ To prevent noise vibration, ensure that
the power cord does not touch any
part of the rear of the unit (e.g. the
heat-exchanger).
∙ When setting up the appliance, ensure
that the power cord is not pinched or
damaged.
∙ Portable multiple sockets or power
supplies must not be placed on the
rear of the appliance.
∙ Ensure that you can pull out the power
plug at any time.
∙ A complete switch-off will only occur
by pulling out the power plug.
Designated use
∙ The appliance is a compressor cooling
device that is exclusively intended
for the cooling and storage of bottles.
No other food may be stored in this
appliance.
∙ The appliance can be used in a
maximum ambient temperature of
32° C.
∙ No responsibility is accepted if
damage results from improper use, or
if these instructions are not complied
with.
Important safety instructions
∙ This appliance is intended for
commercial use.
∙
The cooling circuit in this
appliance contains the
refrigerant isobutane
(R600a), a natural gas
with a high level of environmental
compatibility, which is nevertheless
flammable. Ensure, therefore, that
none of the components of the
refrigerant circuit become damaged
during transportation and installation
of the appliance. If damage to the
cooling circuit does occur, do not
switch on or connect the appliance to
the mains power. In the case that
there is an open fire or any other
sources of ignition in the vicinity of the
11
Werbung
Inhaltsverzeichnis
