Texecom Premier Elite IR Bedienungsanleitung Seite 20

The Premier Elite IR is designed to detect movement of an intruder and activate an
alarm control panel. The product is intended to be connected to a listed burglar
compatible control unit or a power supply that has a voltage output range of
between 9 to 15 VDC and provides a minimum of 4 hours of standby power.
1. Installation guidelines
The technology used in these detectors resists false alarm hazards. However, avoid
potential causes of instability such as
2. Opening the detector
Unwind the screw at the base of the detector until loose; the screw
1.
will be retained in the product
Lift detector lid out from the base and off the lugs at the top
2.
Fig. 2, step
3. Detector knockouts
4. Mounting the detector
5. Coverage & pick-up
6. Premier Elite IR set-up
Set the mounting height by adjusting the position of the PCB.
1.
Wire the detector.
2.
Select the desired jumper settings.
3.
7. Altering Coverage (at 2m Mounting height)
8. End of Line Jumper links
The jumper links JP3 and JP4 are used to select resistances for End-
1.
of-Line (EOL) wiring applications.
JP3: Selects the End-of-Line resistance. Equivalent to wiring a
2.
resistor of the selected value as shown.
INS543-5 20/43
(see Fig.
2).
1).
(see Fig. 2, step1).
(see