Equipment And Accessories; Vacuum Cleaner Preparation; Use Of Vacuum Cleaner; Replacement Of The Dustbag And Filters - Gallet ASP 301 Bedienungsanleitung

II. EQUIPMENT AND ACCESSORIES
A – vacuum cleaner (Fig. 1)
A1 – suction vent
A2 – lid
A3 – lid lock
A4 – handle
A5 – depression for attachment of accessories
A6 – ON/OFF (
A7 – power cord winding button
A8 – dust bag full indicator
A9 – power cord
A10 – rear wheels
A11 – plastic fixture for the dustbag
A12 – dust bag
A13 – input filter
A14 – exhaust grid
A15 – output HEPA filter
III. VACUUM CLEANER PREPARATION
Remove all packing material, take out the vacuum cleaner and the accessories.
Remove all possible adhesion foils, stick-on labels or paper from the appliance.
VACUUM CLEANER ASSEMBLY
When assembling the vacuum cleaner, follow the procedure indicated in Fig. 1.
Choose appropriate accessories as required (B1-B4).
Note
When the dust bag A12 is properly fitted in the plastic fixture A11, the mechanical safety
lock is released and the vacuum cleaner cover can be closed.
IV. USE OF VACUUM CLEANER
Before use, unwind (by pulling) the power cable A9 from the vacuum cleaner to a required
length and plug the vacuum cleaner to the mains.
CONTROL
A6 button - vacuum cleaner ON/OFF switch
A7 button
- when pressed and held, the unwound part of the power cable rewinds
back inside
V. REPLACEMENT OF THE DUSTBAG AND FILTERS
Caution
– Maximum suction performance can be achieved when the filters are clean and the
dustbag is empty.
– When you have replaced the dustbag about five times, the filters need to be cleaned,
or replaced.
) button
B – accessories (Fig. 1)
B1 – floor nozzle
B2 – upholstery nozzle
B3 – brush
B4 – crevice nozzle
B5 – suction hose
B6 – plastic suction tube (2x)
25 / 39
EN