Battery Operation - Thermrup HN611 Gebrauchsanweisung

4.3 Battery operation

• Pull the cable from the battery bag. Connect the cable to the
battery.
• Place the battery in the battery bag.
• Press the on / off switch for approx. 2 seconds to switch on the heating function.
Then press the On / Off button briefly again (several times if necessary) to set the
desired temperature level (level 1-2-3, red -green -blue).
The 1st level is the warmest level. (LED display lights up red)
The 2nd level is the middle level. (LED display lights up green)
The 3rd level is the lower level. (LED display lights up blue)
• The four T-LEDs show the remaining capacity of the battery.
• After 30 seconds, the power button will go into power-saving mode and the LED
indicator will darken, but the heating function will continue. If you desire a different
temperature level during use, briefly press the power button again to unlock it from
power-saving mode. You can then set your desired level as described above.
• Press the on / off switch for approx. 2 seconds to switch off the heating function.
*
Stop using the product if you see redness on your skin. Excessive heat can cause burns!*
4.4 Main Operation
• Connect the charger and the cable of the heating pad with the adapter cable
• Press the controller's power button for approx. 2 seconds
to switch the controller on.
• Then press the power button briefly (several times if necessary)
to set the desired temperature level (1-2-3, red-green-blue).
• Press the power button for approx. 2 seconds to switch off
the controller.
• After use, remove the heating pad from the charger.
*** Please only use the supplied power adapter ***
9