Cleaning The Tool; Environmental Protection - Worx Nitro Leafjet WP544E Serie Originalbetriebsanleitung

Air speed mode
NOTE: The blower is in the air speed
mode for default assembly.
NOTE: The blower has two working
modes: air speed mode and air volume
mode. To change modes, depress the
nozzle release button and slide back-
ward for air speed mode. Slide forward
for air volume mode.
Choose a suitable mode according
to your work. Air speed mode is
recommended for cleaning in grass, as
shown in Fig. H1. While air volume mode
is recommended for cleaning on hard
ground such as cement, as shown in
Fig. H2.
Air volume mode
OPERATION
Starting & Stopping
WARNING! The tool runs for a few
seconds after it has been
switched off.
Let the motor come to a complete
standstill before setting the tool down.
Adjusting the blowing speed / air volume
12
with 2-speed switch
USER TIPS
- Hold the blower tube approximately
8'' above the ground when operating
the tool.
Use a sweeping motion from side
to side. Advance slowly keeping the
accumulated debris/leaves in front of
you.
- After blowing the debris/leaves into a
pile, it is easy to dispose of the pile.
CAUTION!
- Do not blow hard objects such as
nails, bolts, or rocks.
- Do not operate the blower near
bystanders or pets.
- Use extra care when cleaning
debris from stairs or other tight
areas.
- Wear safety goggles or other
suitable eye protection, long pants,
and shoes.
20V Cordless Blower

5.CLEANING THE TOOL

Clean the tool regularly.
WARNING! Keep your product dry. Under
no circumstances spray with water.
- To clean the tool, use only mild soap and a
damp cloth.
See Fig. D
- Do not use any type of detergent, cleaner or
solvent which may contain chemicals that
could seriously damage the plastic.
- Self lubricating bearings are used in
your product, therefore lubrication is not
required.
6.ENVIRONMENTAL
See Fig. PROTECTION
E, F
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
See Fig. G
See Fig.
H1, H2
EN