Noise Data; Assembly And Operation; Vibration Information - Worx Nitro Leafjet WP544E Serie Originalbetriebsanleitung

** X=1-999，A-Z，M1-M9 there are only used for
different customers, there are no safe relevant
changes between these models
*** Voltage measured without workload. Initial
battery voltage reaches maximum of 20 volts.
Nominal voltage is 18 volts.
Category
20V battery
WA3014
20V Charger
WA3880
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.

NOISE DATA

A weighted sound pressure
K
pA
A weighted sound power
K
wA
Wear ear protection.

VIBRATION INFORMATION

Typical weighted vibration
Uncertainty
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained
Using the correct accessory for the tool and ensuring
it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
20V Cordless Blower
Type Capacity
4.0Ah
2.0A
L = 78.0 dB(A)
pA
3.0 dB(A)
L = 92.6 dB(A)
wA
3.0 dB(A)
a < 2.5 m/s
h
K = 1.5 m/s²
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
4.OPERATION
INTENDED USE
The blower is intended for residential use only. Use
the blower outdoors to move yard debris as needed.

ASSEMBLY AND OPERATION

ACTION
ASSEMBLY
Charging the battery pack
Your battery pack is UNCHARGED, you
must charge before use.
More details can be found in charger's
manual.
2
WARNING! The charger and
battery pack are specially
designed to work together, so do not
attempt to use any other devices. Never
insert or allow metallic objects into your
charger or battery pack connections
because of an electrical failure and
hazard will occur.
Installing & removing the battery pack
NOTE: Press the battery release button
to release battery pack from your tool.
After recharging, insert the battery pack
into tool's battery port. A simple push
and slight pressure will be sufficient.
FIGURE
11
See Fig.
A1, A2
See Fig.
B, C
EN